Yasser Alhazmi

1- Troubleshooting and Dismantling motors ,cylinders and actuators to find out the defective part and replace it .

2- Performing Calibration for ( Level , Flow , pressure ) Transmitters , RTD , Thermocouple and PH analyzer.

3- Conduct the Daily PM and maintaining the 5s implementation for the E/I Workshop.

4- a briefly and general knowledge for the PLC & DCS .

5- Responsible for pulling network and extension cables around the factory.

6- Familiar with ( ILD ) and ( PID ) diagrams .

7- Responsible for the integrity and the validation of Brix-Meter certificates.

8- Arrange with SPS all spares ( Motors, cylinder and actuators ) , and its location in the Yard .

9-Connected circuit breakers, transformers, motors and heaters efficiently and accurately, increasing client satisfaction.

10-Handled testing of Motor units and systems, maintaining equipment to best operating standards for for smooth-running operations.

11-Recorded and tracked junior staff maintenance activities, praising successes and swiftly correcting issues.

12-Tested, skillfully located and efficiently repaired electrical malfunctions, exceeding agreed time frames.

13-Read electrical, architectural and mechanical diagrams, drawings and specifications to determine job requirements.

14-Operated precision tools across varied technical tasks.

15-Replaced defective parts for improved equipment longevity.

16-Completed electrical inspection reports to enable fault diagnosis and repair.

17-Planned, scheduled and delegated daily tasks, consistently meeting demands on technical support teams.